Kukko Tools
Series K-70-C
Ball bearing extractor sets "PULLPO"
To remove grooved ball bearings without causing damage and without having to dismantle the shaft.
For use with Ball Bearing sizes ISO 6000-6020; 6200-6212; 6300-6311; 6403-6408
For use with bearings with ID of 10mm - 100mm
The specially developed puller hooks on our series 70 Pullpo can reach into the ball bearing raceway. This design ensures optimum support and higher extraction forces. This makes it possible to disassemble the ball bearing without destroying it.
Removing deep groove ball bearings which are encased within in a housing, but which have no support shaft, requires the use of a Pullpo puller to ensure reliable disassembly without destroying the ball bearing.
For this removal procedure, the spindle is turned over and the slide hammer is used. Thanks to the self-clamping mechanism of the hook and a pressure piece that simulates the shaft, the ball bearing can be removed by striking upward.
Description
- With this puller, grooved ball bearings that are simultaneously located on a shaft and in a casing can be quickly and easily removed.
- Puller is self-tensioning and easy to handle.
- Pulling jaws specifically developed for precise mounting in bearing tracks for optimal support and better extension force.
- Pulling jaws made of two parts. Dowel pin is hammered into the upper end of the jaw.
- The proven KUKKO claw in a newly developed, modern jaw design.
- The two pulling jaw versions are color-coded for easier distinction.
- The pulling jaws are tempered for a long service life.
- The special cross-beam design ensures secure retention of the the part to be removed by the pulling jaws thanks to the spread adjuster.
- Mechanical pressure spindle.
- Rounded spindle head is used with the slide hammer as a spindle top.
- Milled thread treated with special coating.
- Instructions and conversion table in the cover.
- Secure storage in special foam.
Advantage over other Extractors
- Puller is self-tensioning and easy to handle.
- Simple, self-explanatory use with a small number of individual components.
- Simple mounting of the pulling jaws with 90° rotation in the cross-beam.
- Secure, form-fitting connection of the pulling jaws with the cross-beam.
- Only two pulling jaw types required.
- Machined, lateral jaw surfaces ensure optimal jaw alignment with the cross-beam.
- Magnets under the cross-beam ensure simple mounting of the support rings on the ball bearing.
- Spindle head band prevents the wrench from slipping off.
- Non-contact removal possible - in combination with a slide hammer.
KUKKO quality standards
- Quality made in Germany.
- Strong design, high performance and long service life.
- Self-healing corrosion protection KUKKoating for galvanized parts (WITHOUT chrom VI).
See this tool in action HERE
